Richmond Hill Scissor Lift Certification

Richmond Hill Scissor Lift Certification - Scissor lift platforms are made use of at work places to enable tradespeople - like for instance welders, masons and iron workers - to reach their work. Using a scissor lift platform is usually secondary to their trade. Therefore, it is essential that all operators of these platforms be well trained and certified. Regulators, industry and lift manufacturers all work together in order to ensure that operators are trained in safely utilizing work platforms.

Work platforms are likewise known as manlifts or AWPs. These machines are stable and easy to use, although there is always some danger since they lift individuals to heights. The following are various important safety issues common to AWPs:

To be able to protect people working around work platforms from accidental discharge of power because of close working proximities to wires and power lines, there is a minimum safe approach distance (likewise referred to as MSAD). Voltage can arc across the air and cause injury to staff on a work platform if MSAD is not observed.

To be able to ensure maximum steadiness, care must be taken when lowering the work platform. Moving the load towards the turntable, the boom must be retracted. This would help maintain stability during lowering of the platform.

Rules do not mandate individuals working on a scissor lift to tie off. Then again, personnel might be required to tie off if required by employer rules, job-specific risk assessments or local regulations. The anchorage provided by the manufacturer is the only safe anchorage wherein harness and lanyard combinations should be attached.

It is essential to observe and not go beyond the maximum slope rating. The grade could be measured by laying a straight edge on the slope or by laying a board. Next, a carpenter's level can be placed on the straight edge and raised until the end is level. By measuring the distance to the ground and dividing the rise by the length of the straight edge, then multiplying by 100, the per cent slope could be determined.

To be able to determine whether the unit is mechanically safe, a regular walk-around check should be performed. Work site assessments are also necessary to make sure that the work area is safe. This is important specially on changing construction sites due to the risk of obstacles, unimproved surfaces, and contact with power lines. A function test must be carried out. If the unit is utilized safely and correctly and correct shutdown measures are followed, the risks of accidents are greatly reduced.

Click to Download the pdf